香槟华人网助您了解香槟享受香槟


            繁体中文            在线投稿            登录   |   注册

INSTALLATION GUIDE for CLICK PRODUCT on chinaspcflooring.com



作者: heiwhitecom       发布于: Feb 17, 2019 02:04:28 EST


Do you know how to INSTALL the CLICK PRODUCT correctly? Here is the article to guilde you to complete it perfectly.
1# Ensure that the width of first and last row is not less than 2 inches wide. Measure the distance of room in the direction of the width of the plank. 
—Inspect product for defects. If material is questionable, contact the retailer immediately. Do not proceed with installation
—Rack up planks from several boxes. 
—Ensure that end joints are staggered at least 12” between the rows. 

2# Cut off the unsupported tongue of the first row if the first row of floor panels not been trimmed.

3# Ensure there is expansion gaps.

4# Put the short side tongue of the next floor panel 

5# Put final floor panel face up, locking groove long side towards the wall. You may need to lift the floor panel to the left of it slightly to allow for the ‘sliding action

Complete the whole row in the same way. More detail about installation please visit http://www.champaignchinese.com/


(来源:www.chinaspcflooring.com)
没有人评论,您可能是第一个
您要登录后才可评论

Copyright © 2014-2017 champaignchinese.com All Rights Reserved
广告联系 support@champaignchinese.com